Adept technology Adept XUSR Uživatelská příručka stáhnout pdf (Strana 79)

Chapter 6: Optional Equipment Installation

Figure 6-9. Solenoid Placement Using Mounting Hardware

Install the appropriate lengths of 5/32 inch plastic tubing (supplied) into the two output

ports on the manifold.

Route the tubing up along the tower bracket next to the quill and down through

the center of the quill.

Use cable ties as needed to secure the tubing.

10.

Loosen the securing screw on the eAIB chassis, and lower the chassis down flat. See for

the location of the securing screw.

11.

Remove the cable strap plate by removing two screws and split washers. See Figure 6-

10. This allows the harness to move when you lift the J1 cover in the next step.

Adept Cobra ePLC600/800 Robot, User’s Guide, Rev A

Page 79 of 108

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 107 108

Žádné komentáře

Adept technology Adept XUSR Uživatelská příručka Strana 79